Lower Inner Headlamp Mounting Tab, Repairing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Special Tools And Workshop Equipment Required

Torque Screwdriver :VAG1624

-- Switch off the ignition and all electrical consumers and remove the ignition key.

-- Remove the headlamp. Refer to HEADLAMP, REMOVING AND INSTALLING .

-- Remove the rest of the old headlamp mounting tab -1- as illustrated.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mount the new headlamp mounting tab -2- on the bulb socket on the headlamp and tighten the screws -3- to 1.0 Nm.

-- Install the headlamp. Refer to HEADLAMP, REMOVING AND INSTALLING .

NOTE:

If one headlamp is removed, it must always be adjusted after installation.

-- Check the headlamp adjustment and adjust the headlamp if necessary. Refer to