Windshield Washer Fluid Reservoir Filler Tube, Removing And Installing: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electric consumers and remove the key.

-- Remove the bolt -arrow- and the filler tube -2- from its retainer -1-.

Fig 1: Identifying Bolt -Arrow- And Filler Tube -2- To Retainer -1-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove right front wheelhouse liner. Refer to WHEEL HOUSING LINER .

-- Remove the insulation -2- and pull the filler tube -1- out of the rubber seal in the washer fluid reservoir.

Fig 2: Identifying Insulation -2- And Filler Tube -1-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Turn the filler tube and pull it out of the guide toward the engine compartment.