Rear Window Wiper Blade Park Position, Adjusting
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Special Tools And Workshop Equipment Required
- Torque Wrench 1331 5-50Nm:VAG1331
-- Allow the wiper to move to the park position.
The space -A- between the wiper blade lip and the lower edge of the window must be 20 ± 5 mm.
-- If necessary, adjust the rear window wiper park position by repositioning the wiper arm on the wiper motor shaft.
-- Tighten the nut on the wiper arm to the tightening specification found in the assembly overview. Refer to OVERVIEW - REAR WINDOW WASHER SYSTEM .