Shift Lock Solenoid -N110-, Removing And Installing, Vehicles Through 05/2012: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the selector mechanism. SELECTOR MECHANISM, REMOVING AND INSTALLING

-- Disconnect the connector -1- on the Shift Lock Solenoid -N110-.

Fig 1: Identifying Shift Lock Solenoid N110 Electrical Connector & Releasing Retainer & Pulling Out Shift Lock Solenoid N110 From Front

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

When removing the solenoid, lift it in the front slightly so that ball head -2- disengages from operating lever -1-.

Fig 2: Placing Shift Lock Solenoid N110 Into Guide At An Angle From Above

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release retaining hook in direction of -arrow A- and remove the Shift Lock Solenoid -N110- forward in direction of -arrow B-.

Fig 3: Identifying Shift Lock Solenoid N110 Electrical Connector & Releasing Retainer & Pulling Out Shift Lock Solenoid N110 From Front

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.