Shift Lock Solenoid -N110-, Removing And Installing, Vehicles Through 05/2012: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Unclip guide -1- with respect to the emergency release lever in direction of -arrow- on the side.

Fig 1: Emergency Release Lever And Guide

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Selector lever in "S".

-- Pull the emergency release lever -arrow- up.

Fig 2: Identifying Manual Release Lever

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

The operating lever -1- for the Shift Lock Solenoid -N110- moves into its installed position when the emergency release lever is pulled up.

Fig 3: Placing Shift Lock Solenoid N110 Into Guide At An Angle From Above

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- At the same time, install the Shift Lock Solenoid -N110- in the guide at an angle from above and allow it to engage.

The ball head -2- on the Shift Lock Solenoid -N110- must fit into the operating lever on the selector mechanism.

Install In Reverse Order Of Removal.

-- Install the gearshift mechanism. Refer to SELECTOR MECHANISM, REMOVING AND INSTALLING