Output Shaft Seal, Replacing: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- The new ring must be coated with ATF, especially at the sealing lips.

Fig 1: Identifying Oil Seal Sealing Lips

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- First set the :T10180 on the output shaft so that the seal cannot be damaged.

Fig 2: Identifying Output Shaft Seal, Installation

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Drive in the new seal all the way using the :T10180 . Do not tilt the seal when doing this.

-- Check the ATF level and add if necessary. Refer to ATF LEVEL, CHECKING AND FILLING .