ATF, Filling

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION:

This procedure contains mandatory replaceable parts. Refer to component overview prior to starting procedure.

Mandatory Replacement Parts

Seal - Plug

-- Install the Oil Filler - Adapter 2:VAS6262/2 hand tight, with the engine >>running<<.

Fig 1: Identifying Oil Filling Adapter VAS 6262/2 Installed

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Shake before opening.

-- Read the information regarding the bleeder pipe before attaching the Oil Filler:VAS6262A to the fluid container. Refer to ATF LEVEL, CHECKING AND FILLING .

-- Fill 1.0 liters (1.05 quarts) of ATF.

-- Remove the Oil Filler:VAS6262A at the quick-release coupling and check it.

If ATF Flows Out of Adapter Hole

ATF does not need to be topped off.

-- Allow ATF to drain until it drips.

-- Fasten ATF check plug with new seal to 16 Nm. The ATF level test is now completed.

If ATF Does Not Drip

-- Add another liter (1.05 quarts). Refer to ATF, FILLING .

WARNING:

Too little or too much ATF will impair the transmission. If 2 liters (2.1 quarts) are missing, you should check the transmission more closely. There is probably a >>larger leak.<<