Rear Final Drive, Removing And Installing: Installing
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Install in reverse order of removal. Note the following:
Always replace the locking ring on the final drive pin.
-- Attach the driveshaft to the final drive pin so that the color markings applied at the factory or retroactively made markings align with the color marking that was made earlier -arrow-.
-- Attach the rear final drive to the subframe. Refer to -arrows- .
-- Installation is performed in reverse order of removal.
-- Check the transmission fluid level in the rear final drive. Refer to REAR FINAL DRIVE, CHECKING TRANSMISSION FLUID .
| Tightening Specification | |
|---|---|
| Center support to the body | 20 Nm |