Axle Differential Lock Control Module -J647-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Turn off the ignition and all electric consumers.

-- Remove lock carrier cover. Refer to STORAGE COMPARTMENTS, COVERS AND TRIM .

-- Remove the right D-pillar trim. Refer to D-PILLAR TRIM, REMOVING AND INSTALLING .

-- Remove the clip -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the side trim panel on the side window and carefully push it slightly to the side in direction of -arrow-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- If necessary, disconnect the connectors and unclip the interior lamp from the side trim panel.

-- Release and disconnect the connector -1- from the Axle Differential Lock Control Module -J647-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Unclip the Axle Differential Lock Control Module -J647- from the bracket -2- and remove it -3-.