Rear Driveshaft, Removing And Installing: Notes
WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Torque Wrench 1331 5-50Nm:VAG1331
- Torque Wrench 1332 40-200Nm:VAG1332
- 600 mm extractor lever (for example, Hazet 652-24)
A two-column shop hoist should be used when working on the rear driveshaft.
NOTE:
Mark the position of all the parts to each other before removing them. Install in the same position otherwise the imbalance will be excessive and the bearings could get damaged causing rumbling noises.
Do not bend the rear driveshaft, only store it fully extended.