LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1207 (Final Drive, Differential (0C8)) >> 39 Final Drive, Differential >> Driveshaft >> Front Driveshaft, Removing And Installing >> Front Driveshaft, Removing And Installing, Driveshaft With Joint On Both Sides >> Notes

Front Driveshaft, Removing And Installing, Driveshaft With Joint On Both Sides: Notes

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required 

A two-column workshop hoist should be used when working on the front driveshaft.

NOTE:

Mark the position of all the parts to each other before removing them. Install in the same position otherwise the imbalance will be excessive and the bearings could get damaged causing rumbling noises.

scientia non olet · About LEMON Manuals