Center Support, Replacing: Disassembling

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear driveshaft. Refer to REAR DRIVESHAFT, REMOVING AND INSTALLING .

-- Mount the driveshaft on the installed Driveshaft Alignment Fixture:3139 in a vise.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Only loosen the clamps on the driveshaft tube on which the center support is located.

-- Open the large clamp on the driveshaft tube boot.

-- Disconnect the driveshaft tube boot and push back. Pry out the circlip -1- in the driveshaft tube with a tool, or example a screwdriver.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Before disassembling the driveshaft mark the position of the components to each other. Install in the same position otherwise the imbalance will be excessive and the bearings could get damaged causing rumbling noises.

-- Push back the driveshaft boot until the ball cage is viable. Mark the installed position of all components to each other -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the driveshaft tube.

-- Drive out the cap -2- with an appropriate tool such as a drift -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

Always replace the cap after removing.

-- Remove the ball cage from the hub.

-- Loosen the small clamp and remove the boot from the hub.

-- Tension the center support in the Puller - Kukko Separating Tool - Diameter 25-155mm:15/3 and press it off of the driveshaft hub.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A centrifugal disk will be pressed out at the same time with the center support. Always replace the centrifugal disk after removing.