Differential Lock Motor -V304-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Replace the O-ring -arrow- on the Differential Lock Motor -V304-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

NOTE:

A replacement Differential Lock Motor -V304- is supplied with the O-ring installed.

The O-ring is secured by a protective cover.

Remove the protective sleeve before installing the Differential Lock Motor -V304-.

-- Install the Differential Lock Motor -V304- -A- and the bracket for the connector -B- in the rear final drive with four bolts. Tightening specification. Refer to Installing .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Connect the two connectors to the Differential Lock Motor -V304-.

-- Check the transmission fluid level in the rear final drive. Refer to REAR FINAL DRIVE, CHECKING TRANSMISSION FLUID .

Tightening Specification
Differential Lock Motor -V304- to rear final drive	8 Nm