Transmission Support And Bracket, Removing And Installing: Removing

WARNING: This page is about a different car, the 2014 Volkswagen Touareg, 2013 Volkswagen Touareg, 2012 Volkswagen Touareg, and 2011 Volkswagen Touareg. However, it is still accessible from the selected car via links, so may be relevant.

-- Lift the vehicle.

-- Remove the noise insulation to the bottom of the transmission.

-- Remove the impact guard under the transmission support and bracket, if equipped. Refer to appropriate service information. .

-- Position the Engine and Gearbox Jack :VAS6931 with the Engine/Gearbox Jack - Gearbox Support :T10337 under the transfer case.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the exhaust system if secured on the transmission support. Refer to EXHAUST MANIFOLD [For engine(s) CGRA] .

-- Remove the bolts -1 and 2- from the transmission support.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Lower the transfer case slightly until the transmission support hangs free.

-- Remove the transmission support from the transfer case bracket -arrows- and then remove the transmission support.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -1 and 2- and removed the bracket from the transfer case.