Overview - Timing Chain Cover: Notes
WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- Bolt
- Tightening Specification and sequence. Refer to Figure.
- Crankshaft Shaft Seal, Transmission Side
- Replacing. Refer to CRANKSHAFT SEAL, REPLACING, TRANSMISSION SIDE .
- Bolt
- Tightening Specification and sequence. Refer to Figure.
- Alignment Sleeve
- Quantity: 2
- Bolt
- Tightening Specification. Refer to -item 13) OVERVIEW - OIL FILTER/OIL PRESSURE SWITCH - Bolt .
- Left Cylinder Head Gasket
- Left Timing Chain Cover
- Removing and installing. Refer to LEFT AND RIGHT TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Bracket
- For wiring harness
- Bolt
- Replace
- Tightening Specification and sequence. Refer to Figure.
- Lower Timing Chain Cover
- Removing and installing. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Seals
- Replace
- Bolt
- Tightening Specification and sequence. Refer to Figure.
- Bracket
- For the connectors
- Bolt
- Replace
- Tightening Specification and sequence. Refer to Figure.
- Right Timing Chain Cover
- Removing and installing. Refer to LEFT AND RIGHT TIMING CHAIN COVER, REMOVING AND INSTALLING .
- Right Cylinder Head Gasket
- Alignment Sleeve
- Quantity: 2
- Bolt
- Tightening Specification and sequence. Refer to Figure.
- Engine Speed Sensor -G28-
- Removing and installing. Refer to ENGINE SPEED SENSOR -G28-, REMOVING AND INSTALLING .
- Bolt
- Tightening Specification. Refer to OVERVIEW - IGNITION SYSTEM .