Lower Timing Chain Cover, Removing And Installing: Removing

WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

The transmission is removed.

NOTE:

When Installing, Bring All Cable Ties Back To Same Positions.

Fig 1: Identifying Battery

Courtesy of AUDI OF AMERICA, LLC

CAUTION:

Danger Of Causing Damage To Electronic Components.

Observe the steps for disconnecting the battery.

-- Switch the ignition off and remove the ignition key.

-- Disconnect the battery ground cable -2-. Refer to BATTERY .

-- Remove the drive plate. Refer to DRIVE PLATE, REMOVING AND INSTALLING .

-- Remove the left and right timing chain covers. Refer to LEFT AND RIGHT TIMING CHAIN COVER, REMOVING AND INSTALLING .

-- Remove the oil filter housing. Refer to OIL FILTER HOUSING, REMOVING AND INSTALLING .

-- Remove the generator. Refer to GENERATOR .

-- Remove the left and right bolts -arrows- and the electrical connector bracket.

Fig 2: Cylinder Bank 2 Oxygen Sensor Electrical Connectors

Courtesy of AUDI OF AMERICA, LLC

NOTE:

Ignore items -1 and 4-.

-- Disconnect the starter connector -3- by sliding the retainer back and pressing the release down.

Fig 3: Disconnecting Starter Electrical Connector

Courtesy of AUDI OF AMERICA, LLC

-- Remove the electrical wire nut -2- and starter.

NOTE:

Ignore items -1 and 4-.

-- Remove the bolts -arrows-.

Fig 4: Identifying Lower Timing Chain Cover Bolt Loosening And Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -1 through 10- and remove the lower timing chain cover.

-- Press the transmission side of the crankshaft shaft seal out of the lower timing chain cover.