Compression Pressure, Checking: Procedure: Assembling

WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening Specification. Refer to OVERVIEW - CYLINDER HEAD .

Assemble in reverse order of disassembling. Note The Following:

NOTE:

Secure All Hose Connections With Hose Clamps Of The Same Type As Those Equipped By The Factory.

-- Install the spark plugs. Refer to appropriate service information.

-- Install the air filter housing. Refer to OVERVIEW - AIR FILTER HOUSING .

-- If the engine was started while the electrical connectors were disconnected, then the following fault is stored in the engine control module: "generate readiness code" in "Guided Functions " using the Vehicle Diagnostic Tester.