Ribbed Belt, Removing And Installing: Installing

WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Placing Ribbed Belt Over Belt Pulley

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note The Following:

-- Route the ribbed belt -2- in the specified sequence over the ribbed belt pulley.

1 - Generator

3 - Idler Roller

4 - Vibration damper

5 - Tensioner

NOTE:

When Installing The Ribbed Belt, Make Sure It Is Seated Correctly On The Pulleys.

-- Start the engine and check the belt routing.

-- Install the noise insulation. Refer to NOISE INSULATION, REMOVING AND INSTALLING .