Sealant Applied On Cylinder Block (For Guide Frame)
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
-- Clean The Sealing Surfaces; They Must Be Free Of Oil And Grease.
CAUTION:
The Lubrication System Could Be Plugged With Excess Sealant.
- Do Not Apply Sealant Beads Thicker Than Indicated.
-- Apply Sealant Beads -Arrows- To The Clean Sealing Surfaces As Shown In The Illustration.
- Thickness Of Sealant Beads: 2.0 mm.
-- Position Seals -1 Through 4-.
NOTE:
The Guide Frame Must Be Installed Within 5 Minutes After Applying The Sealant.
Installation Position Of Alignment Bushings
-- If There Are No Alignment Bushings -Arrows- At The Locations Marked In The Guide Frame, Insert Them.