Guide Frame Tightening Specifications And Sequence
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace Any Bolts That Were Tightened With An Additional Turn.
-- Tighten The Bolts In Six Steps In The Sequence Shown.
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 10- | 30 Nm |
| 2. | -11 to 20- | 30 Nm |
| 3. | -1 through 10- | 50 Nm |
| 4. | -1 through 10- | Tighten an additional 90° |
| 5. | -11 to 20- | 50 Nm |
| 6. | -11 to 20- | Tighten an additional 90° |
-- Tighten the guide frame to cylinder block sealing surface bolts, -highlighted in dark-, in a diagonal sequence to 9 Nm.