Engine To S TRONIC Transmission 0B5

WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Checking If Alignment Sleeves -A- For Centering Engine/Transmission Are In Cylinder Block

Courtesy of AUDI OF AMERICA, LLC

Item

Bolt

1 ¹⁾

M10x50 ²⁾

2 ¹⁾ , 3, 4, 5, 6

M12x100 ³⁾

30 +90°

7 ⁴⁾

M12 x 175 ³⁾

30 +90°

8, 9, 10

M10x60 ³⁾

15 +90°

Alignment sleeves for centering

¹⁾ Also secures the starter.
²⁾ Bolt class 10.9. There is no limit to the number of times the steel bolt can be used again.
³⁾ Aluminum bolts may be used two times ENGINE, INSTALLING .
⁴⁾ Vehicles with electro-mechanical power steering: with nut and washer. Counterhold the nut when loosening and tightening.

⁽¹⁾	To prevent damaging the bolts when marking them, do not clamp them in a vise. Insert the bolt using a 14 mm socket with a /₂ drive, which is inserted in to the vise, as illustrated.

The aluminum bolts -2 to 10- may be used twice. Therefore, the bolts must be marked with two notches "X" made by a chisel after they have be used the first time -arrow-.

Fig 2: Identifying Aluminum Bolts Marked With An "X"
Courtesy of AUDI OF AMERICA, LLC
Bolts marked with an "X" may not be used again.