Drive The Cap -1- In Without Sealant Using The:T10174.

Courtesy of AUDI OF AMERICA, LLC

• Installation depth -a- = 1 to 2 mm.

Courtesy of AUDI OF AMERICA, LLC

-- Turn the vibration damper to the "TDC" -arrow- position.

• When turning the crankshaft, make sure that no components are not damaged by the timing chain.
• The notch on the vibration damper must align with the arrow marking on the lower timing chain cover.

-- Turn the intake camshaft in direction of -arrow 1- until the marking -3- aligns with the :T40271/2  .

Courtesy of AUDI OF AMERICA, LLC

-- Slide the :T40271/2  into the chain sprocket splines in the direction of -arrow 2-.

With Wrench Clearance: 

Courtesy of AUDI OF AMERICA, LLC

-- Turn the exhaust camshaft in the direction of -arrow 1- until the marking -3- aligns with the :T40271/1  .

-- Slide the :T40271/1  into the chain sprocket splines in the direction of -arrow 2-.

Without Wrench Clearance: 

Courtesy of AUDI OF AMERICA, LLC

-- Bolt the :T40271/1  to the cylinder head.

The Help Of A Second Technician Is Necessary For The Following Steps.

-- Turn the exhaust camshaft in the direction of -arrow A- until the marking -1- aligns with the :T40271/1  .

-- Slide the :T40271/1  into the chain sprocket splines in the direction of -arrow B-.

-- Mount the camshaft timing chain. Refer To CAMSHAFT TIMING CHAIN, REMOVING FROM CAMSHAFTS .

-- Install The Air Filter Housing. Refer To AIR FILTER HOUSING, REMOVING AND INSTALLING .

There Are Additional Procedures Depending On The Model. Refer To CAMSHAFT, REMOVING AND INSTALLING / CAMSHAFT, REMOVING AND INSTALLING  .