Ignition Coils, Removing And Installing: Notes

Special tools and workshop equipment required 

• Puller - Ignition Coil:T40039 

Remove the ignition coils from cylinder bank 1: 

-- Only remove the lower section of the air filter for the cylinder 1 ignition coil LOWER SECTION OF AIR FILTER, REMOVING .

-- For cylinder 2 and 3 ignition coils, remove the air guide hose (open the hose clamp -3- and the clips -arrows-).

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts from the ignition coil wiring harness.

-- Release electrical connectors and remove connectors simultaneously from ignition coils.

-- Pull ignition coils out of spark plug shaft using Puller - Ignition Coil:T40039  .

Courtesy of AUDI OF AMERICA, LLC

Remove the ignition coils from cylinder bank 2: 

-- Remove the coolant reservoir -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the connector to the Engine Coolant Level Warning Switch -F66- on the bottom of the coolant reservoir and lay the reservoir aside with the coolant hoses -1 and 2- and -3- attached.

-- Remove the bolts -arrows-.

Courtesy of AUDI OF AMERICA, LLC

-- Pull the ignition coil approximately 30 mm out of spark plug shaft using Puller - Ignition Coil:T40039  .

-- Release electrical connectors and remove connectors simultaneously from ignition coils.

Courtesy of AUDI OF AMERICA, LLC