Camshaft Position Sensor, Removing And Installing: Removing
WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
-- Disconnect the connector on the respective camshaft position sensor.
-- Remove the air filter lower section to remove the Camshaft Position Sensor 3 -G300- on cylinder bank 1. Remove the lower section of the air filter LOWER SECTION OF AIR FILTER, REMOVING
-- Remove the coolant reservoir to remove the Camshaft Position Sensor 4 -G301- on cylinder bank 2.
-- Disconnect the connector to the Engine Coolant Level Warning Switch -F66- on the bottom of the coolant reservoir and lay the reservoir aside with the coolant hoses -1 and 2- and -3- attached.