Ignition Coils, Removing And Installing: Removing

WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the engine cover. Refer to ENGINE COVER, REMOVING AND INSTALLING .

-- Remove the affected air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

Fig 1: Identifying Air Filter Housing Bracket Components

Courtesy of AUDI OF AMERICA, LLC

-- Remove the nuts and bolts -arrows- to then remove the air filter housing bracket -1-.

-- Remove the bolts -1 and 2-.

Fig 2: Identifying Bolts & Ignition Coils Electrical Harness Connectors

Courtesy of AUDI OF AMERICA, LLC

-- Remove the ignition coils with the Puller - Ignition Coil:T40039 approximately 30 mm out from the spark plug shaft.

Fig 3: Identifying Ignition Coil Puller T40039 Removing Ignition Coils

Courtesy of AUDI OF AMERICA, LLC

-- Release the connectors and simultaneously disconnect them from the ignition coils.

-- remove the ignition coils.