Power Steering Pump Drive Seal, Replacing: Procedure

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove The Power Steering Pump. Refer To OVERVIEW - POWER STEERING PUMP .

-- Rotate the spindle on the :T40195 all the way back.

Fig 1: Identifying Puller - Shaft Seal T40195

Courtesy of AUDI OF AMERICA, LLC

-- Lubricate the seal remover threaded head, position it, and then install it into the shaft seal as far as possible using strong force.

-- Rotate the inner section of the seal puller against the spur gear unit until the shaft seal is removed.

NOTE:

If the shaft seal breaks, position the seal puller a second time and remove the rest of the seal.

-- Clamp the seal puller in a vise at the hex bolt and remove the shaft seal with pliers.

-- Clean the running and sealing surface.

-- Install the power steering pump drive seal in as far as it will go using the :T40193 .

Fig 2: Driving Power Steering Pump Drive Shaft Seal In As Far As Stop Using T40193

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The installation location is shown with the engine removed.

-- Install the power steering pump. Refer to OVERVIEW - POWER STEERING PUMP .