Pistons, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following :

Tightening Specification. Refer to OVERVIEW - PISTON AND CONNECTING ROD .

NOTE:

Replace any bolts that were tightened with an additional turn.

-- Coat the contact surfaces on the bearing shells with oil.

-- Install the piston and piston ring compressor.

Installed position:

Piston. Refer to Figure.
Connecting rod. Refer to Figure.

-- Install the connecting rod bearing cap according to the marking.

-- Install the oil pan upper section. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .

-- Install the cylinder head. Refer to CYLINDER HEAD, INSTALLING .