LEMON Manuals: Even more car manuals for everyone
Home >> Audi >> 2016 >> S5 Prestige, 2D Convertible >> Repair and Diagnosis >> External Pages >> Different car >> Section 1177 (Crankshaft, Cylinder Block [CAUA] (Coupe)) >> 13 Crankshaft, Cylinder Block >> Cylinder Block, Transmission Side >> Drive Plate, Removing And Installing >> Installing

Drive Plate, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following: 

NOTE:

Replace Any Bolts That Were Tightened With An Additional Turn.

Vehicles With A Manual Transmission: There Is A Needled Bearing In The Drive Plate. Check If The Needle Bearing Is Inserted Before Installing. Remove Needle Bearing From Drive Plate And Install. Refer To NEEDLE BEARING IN DRIVE PLATE, REPLACING, VEHICLES WITH MANUAL TRANSMISSION .

-- Pay Attention To The Alignment Bushing When Installing The Drive Plate.

-- Turn The :10-201  To Tighten The Bolts.

scientia non olet · About LEMON Manuals