Vibration Damper, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening Specification. Refer to Figure.

NOTE:

Replace Any Bolts That Were Tightened With An Additional Turn.

Clean The Threaded Holes With A Thread Tap.

Install The Bolts With Locking Compound; Locking Compound.

The Vibration Damper Can Only Be Installed In One Position. Refer To Figure.

-- Install The Ribbed Belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Install The Fan Shroud. Refer to FAN SHROUD, REMOVING AND INSTALLING .