Guide Frame Tightening Specifications And Sequence
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Replace Any Bolts That Were Tightened With An Additional Turn.
-- Tighten The Bolts In Five Steps In The Sequence Shown.
| Step | Bolts | Tightening Specification/Additional Turn |
|---|---|---|
| 1. | -1 through 10- | 30 Nm |
| 2. | -11 to 20- | 20 Nm |
| 3. | -1 through 10- | 50 Nm |
| 4. | -11 to 20- | 30 Nm |
| 5. | -1 to 20- | Tighten an additional 90° |
-- Tighten the guide frame to cylinder block sealing surface bolts, -highlighted in dark-, in a diagonal sequence to 9 Nm.