Overview - Radiator/Coolant Fan: Notes
WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
There is a risk of injury if the radiator fan turns on by itself.
- Disconnect the connectors before working near the fan shroud.
- Coolant Fan Control Module -J293-
- Separate or connected to the Coolant Fan -V7-, depending on vehicle equipment
- Separates Coolant Fan Control Module -J293-, removing and installing Coolant Fan Control Module -J293-, REMOVING AND INSTALLING
- Bolt
- 4.5 Nm
- Bolt
- 5 Nm
- Fan Shroud
- Removing and installing; A4 together with the radiator (refer to COOLER, REMOVING AND INSTALLING ), A5 (refer to FAN SHROUD, REMOVING AND INSTALLING ).
- Coolant Fan -V7-
- Separate or connected to the Coolant Fan Control Module -J293-, depending on vehicle equipment
- Coolant Fan - V7-, Removing and Installing. Refer to COOLANT FAN, REMOVING AND INSTALLING .
- Bolt
- 3.5 Nm
- Backing Plate
- Rubber Bushing
- For the radiator
- Coolant Hose
- Lift the retaining clamp to remove
- Connect to the radiator. Refer to Figure
- O-Ring
- Replace
- O-Ring
- Replace
- Coolant Hose
- Lift the retaining clamp to remove
- Connect to the radiator. Refer to Figure
- Coolant Hose
- To the coolant reservoir
- O-Ring
- Replace
- Radiator
- Removing and installing; A4 together with the fan shroud (refer to COOLER, REMOVING AND INSTALLING ), A5 (refer to COOLER, REMOVING AND INSTALLING ).
- After replacing, replace entire amount of coolant
- Retaining Pin
- Disengage and remove using screwdriver
- Rubber Buffer
- Radiator Bracket
- Bolt
- O-Ring
- Replace
- Coolant Hose
- Lift the retaining clamp to remove
- Connect to the radiator. Refer to Figure
- Coolant Fan 2 -V177-
- Not with the 400 W fan activation
- Separate or connected to the coolant fan control module, depending on vehicle equipment
- Removing and installing. Refer to COOLANT FAN, REMOVING AND INSTALLING .
- Bolt
- 5 Nm