Fan Shroud, Removing And Installing: Removing
-- Remove the front noise insulation -1-. Refer to NOISE INSULATION .
-- Push the retainer back -arrow-, press the release down and disconnect the coolant fan connector -1- and if equipped -2-.
Vehicles with multitronic transmission 0AW/automatic transmission 0B6:
-- Place the Used Oil Collection and Extraction Unit:SMN372500 under the separating point.
Follow the rules for clean working conditions when working on the transmission. .
-- Remove the bolts -arrow- and disconnect the ATF lines from the radiator.
To prevent ATF from leaking, secure all ATF lines to the top of the longitudinal member.
-- Close open lines and connections with clean plugs from the Engine Bung Set:VAS6122 .
Continuation for all vehicles:
-- Remove the bolts -1- and -2- and remove the bumper cover end panel toward the rear.
-- Remove the left and right bolts -1-.
Ignore -arrow-.
-- Remove the bolts -1, 2, 3 and 5-.
-- Lift the lock carrier cover -4- and disengage it from the radiator grille.
-- Remove the bolts -arrows-.
-- Remove the air duct -1- from the air filter housing intermediate flange -2-.
-- If applicable, release the clamps -arrow A- and tilt the power steering coolant hose -1- forward -arrow B-.
-- Release the retaining tabs -A arrows- and tilt the left and right air ducts -1- toward the center of the vehicle -arrow B-.
-- Release the left and right radiator retaining pins and remove by pulling upward -arrows-.
-- Pull the right side of the radiator forward -arrow B-, then press right -arrow A- and pull then left side forward -arrow C-.
-- Press the fan shroud left and right locking tabs at the same time -arrow- and remove the fan shroud upward from the radiator.