Upper Coolant Pipes, Removing And Installing: Installing

WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification. Refer to OVERVIEW - COOLANT PIPES .

Install in reverse order of removal. Note The Following:

NOTE:

Replace the O-rings.

-- Clean and smooth the o-ring sealing surface.

-- Coat the o-ring with coolant and slide it onto the coolant pipe.

-- Install the high pressure line. Refer to HIGH PRESSURE PIPE, REMOVING AND INSTALLING .

-- Install the intake manifold upper section. Refer to Fuel Pressure Sensor -G247-, REMOVING AND INSTALLING .

-- Fill the coolant. Refer to FILLING .