Front Coolant Pipes, Removing And Installing: Installing

WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification. Refer to OVERVIEW - COOLANT PIPES .

Install in reverse order of removal. Note The Following:

NOTE:

Replace the seal and o-ring.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Clean and smooth the gasket sealing surfaces.

-- Coat the gaskets with coolant and slide them onto the coolant pipe.

-- Install the left coolant pipes. Refer to LEFT COOLANT PIPES, REMOVING AND INSTALLING .

-- Install the A/C compressor. Refer to A/C COMPRESSOR .

-- Install the ribbed belt pulley for the power steering pump. Refer to POWER STEERING HYDRAULICS .

-- Install the After-Run Coolant Pump -V51-. Refer to After-Run Coolant Pump -V51-, REMOVING AND INSTALLING .

-- Install the front wheel housing liner. Refer to WHEEL HOUSING LINER .

-- Install the front wheel. Refer to WHEELS AND TIRES .

-- Install the coolant pump ribbed belt pulley. Refer to OVERVIEW - COOLANT PUMP/THERMOSTAT .

-- Install the ribbed belt. Refer to RIBBED BELT, REMOVING AND INSTALLING .

-- Install the After-Run Coolant Pump -V51-. Refer to After-Run Coolant Pump -V51-, REMOVING AND INSTALLING .

-- Fill the coolant. Refer to FILLING .