Overview - Radiator/Coolant Fan: Notes
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger Of Personal Injury Due To The Coolant Fan Turning On By Itself.
- Disconnect The Connectors Before Working Near The Fan Shroud.
- Coolant Hose
- Lift The Retaining Clamp To Remove
- Connecting. Refer To Figure
- O-Rings
- Replacing
- Coolant Hose
- Lift The Retaining Clamp To Remove
- Connecting. Refer To Figure
- O-Ring
- Replacing
- Coolant Hose
- Lift The Retaining Clamp To Remove
- Connecting. Refer To Figure
- Bolt
- Tightening Specification. Refer To the appropriate Service Information .
- ATF Line
- Removing and installing. Refer To the appropriate Service Information .
- O-Rings
- Replacing
- Bolt
- Tightening Specification. Refer To the appropriate Service Information .
- ATF Line
- Removing And Installing. Refer To the appropriate Service Information .
- Air Guide
- Radiator
- With integrated ATF cooler
- Removing and installing. Refer To RADIATOR, REMOVING AND INSTALLING .
- After Replacing, Replace Entire Amount Of Coolant
- Condenser
- Removing and installing. Refer To CONDENSER, REMOVING AND INSTALLING .
- Hydraulic Fluid Cooler
- For Vehicles With Hydraulic Power Steering
- Removing And Installing. Refer To HYDRAULIC FLUID COOLER, REMOVING AND INSTALLING .
- Rubber Bushing
- For Auxiliary Cooler
- Coolant Auxiliary Cooler
- Right
- Removing and installing. Refer To AUXILIARY COOLER, REMOVING AND INSTALLING .
- After Replacing, Replace Entire Amount Of Coolant
- Rubber Bushing
- For Auxiliary Cooler
- Bracket
- For Auxiliary Cooler
- Bolt
- 3.5 Nm
- Nut
- 8 Nm
- Nut
- 8 Nm
- Retaining Pin
- Disengage And Remove Using Screwdriver
- Rubber Bushing
- For The Radiator
- Rubber Bushing
- For The Radiator
- Bracket
- For The Radiator
- Bolt
- Backing
- Bolt
- 4.5 Nm
- Sealing Strip