Connection Diagram - Coolant Hoses
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Risk Of Scalding Due To Hot Steam And Hot Coolant.
- The Coolant System Is Under Pressure When The Engine Is Warm.
- Cover The Coolant Reservoir Cap With A Cloth And Then Open It Slowly To Release The Pressure.
NOTE:
Secure All Hose Connections With Hose Clamps Of The Same Type As Those Equipped By The Factory.
The Arrows On The Coolant Pipes And Ends Of Coolant Hoses Must Align.
- Coolant Auxiliary Cooler
- Right
- Change The Coolant After Replacing
- Coolant Thermostat
- For Right Coolant Auxiliary Cooler
- After-Run Coolant Pump -V51-
- Generator
- Engine Oil Cooler
- Change The Coolant After Replacing
- Cylinder Head
- Cylinder Bank 1 (Right)
- Change The Coolant After Replacing
- Coolant Reservoir
- Cap
- Check The Pressure Relief Valve. Refer To PRESSURE RELIEF VALVE IN CAP, CHECKING .
- Bleeder Hole
- Inside The Coolant Hose To The Heater Core For The Heating
- Heater Core for Heater
- Change The Coolant After Replacing
- Crankcase Housing Ventilation
- Cylinder Head
- Cylinder Bank 2 (Left)
- Change The Coolant After Replacing
- Engine Coolant Temperature Sensor -G62-
- Coolant Pump
- Map Controlled Engine Cooling Thermostat -F265-
- Coolant Auxiliary Cooler
- Left
- Change The Coolant After Replacing
- Check Valve
- ATF Cooler
- Integrated Inside The Radiator
- Radiator
- Change The Coolant After Replacing