Overview - Engine Oil Cooler: Notes
WARNING: This page is about a different car, the 2015 Audi RS 5, 2014 Audi RS 5, and 2013 Audi RS 5. However, it is still accessible from the selected car via links, so may be relevant.
- Bracket
- For the front engine oil cooler
- Nut
- 6 Nm
- Bolt
- 9 Nm
- Lock Carrier
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Depending on the date of manufacture, threaded pin with nut
- Hose/line Assembly
- For engine oil
- O-Ring
- Replacing
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- O-Ring
- Replacing
- Engine Oil Cooler
- Removing and installing. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Seals
- Replacing
- Bolt
- 9 Nm
- O-Rings
- Replacing
- Hose/line Assembly
- For engine oil
- Bonded Rubber Bushing
- Install all the way in by hand.
- Oil Pipe
- Bolt
- 9 Nm
- O-Ring
- Replacing
- Front Engine Oil Cooler
- Removing and installing. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING, FRONT .
- Air Guide
- Bolt
- 7 Nm
- Bolt
- 9 Nm
- Bracket
- For the front engine oil cooler
- Nut
- 6 Nm
- Bonded Rubber Bushing
- Install all the way in by hand.