Overview Oil Pan/Oil Pump: Notes
WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 9 Nm
- Oil Level Thermal Sensor -G266-
- Removing and installing. Refer to Oil Level Thermal Sensor -G266-, REMOVING AND INSTALLING .
- Seal
- Replace
- Oil Pan Lower Section
- Removing and installing. Refer to OIL PAN LOWER SECTION, REMOVING AND INSTALLING .
- Bolt
- 9 Nm
- Lower Oil Baffle
- Bolt
- Tightening specification and sequence. Refer to Figure.
- Oil Pan Upper Section
- Removing and installing. Refer to OIL PAN UPPER SECTION, REMOVING AND INSTALLING .
- Alignment Sleeve
- Quantity: 2
- O-Ring
- Insert into guide frame
- Replace
- Bolt
- 9 Nm
- Install with locking compound. For the correct locking compound.
- Upper Oil Baffle
- Seal
- Insert into guide frame
- Replace
- Seal
- Replace
- Bolt
- 9 Nm
- Engine Oil Cooler
- See note. Refer to DAMAGED CRANKSHAFT OR ROD BEARINGS, NOTE .
- Removing and installing. Refer to ENGINE OIL COOLER, REMOVING AND INSTALLING .
- With oil cooler bypass valve
- Bolt
- 9 Nm
- Oil Pump Drive Axle
- Pressure Spring
- Sleeve
- Quantity: 2
- Mounting Bracket
- Bolt
- 9 Nm
- Chain Sprocket for Oil Pump
- Can only be placed onto drive axle in one position
- Bolt
- 30 Nm + 90° turn
- Replace
- To loosen, counterhold on sprocket with Wrench - Pin Type:3212 .
- O-Ring
- Replace
- Seal
- Replace
- O-Ring
- Replace
- Oil Pump
- Do not disassemble
- Removing and installing. Refer to OIL PUMP, REMOVING AND INSTALLING .
- Bolt
- 20 Nm
- Bolt
- Replace
- Tightening specification and sequence. Refer to Figure.
- Seal
- Replace
- Oil Drain Plug
- 30 Nm