Oil Pan Upper Section, Removing And Installing: Installing

• Tightening Specifications. Refer to OVERVIEW - OIL PAN/OIL PUMP  and Figure.

Fig 1: Identifying Rotating Plastic Brush For Removal Of Sealant From Upper Part Of Oil Pan And Cylinder Block

Courtesy of AUDI OF AMERICA, LLC

-- Remove sealant residue on the upper section of the oil pan and the cylinder block, for example using a rotating plastic brush.

-- Clean the sealing surfaces. They must be free of oil and grease.

NOTE:

Note The Expiration Date Of The Sealing Compound. 

Fig 2: Cut Tube Nozzle At Front Marking

Courtesy of AUDI OF AMERICA, LLC

-- Cut the tube nozzle at the front marking (nozzle diameter: about 1.5 mm).

Fig 3: Applying Sealant Bead On Clean Sealing Surface Of Upper Section Of Oil Pan

Courtesy of AUDI OF AMERICA, LLC

-- Apply a sealant bead -arrow- to the clean sealing surface on the upper section of the oil pan as shown in the illustration.

• Completely fill the grooves on the sealing surfaces with sealant.
• The sealant bead must be 1.5 to 2.0 mm above the sealing surface.

-- Insert the seal -1- and the o-ring -2- in the guide frame.

Fig 4: Inserting Seal And O-Ring In Guide Frame

Courtesy of AUDI OF AMERICA, LLC

-- Position the oil pan upper section and tighten the bolts. Refer to Figure.

Fig 5: Identifying Upper Oil Pan Bolt, Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

Install in reverse order of removal. Note The Following: 

-- Install the oil pump. Refer to OIL PUMP, REMOVING AND INSTALLING .

-- Install the timing chain cover lower section. Refer to LOWER TIMING CHAIN COVER, REMOVING AND INSTALLING .