Engine Oil Cooler, Removing And Installing: Installing

WARNING: This page is about a different car, the 2010 Audi A5, 2009 Audi A5, and 2008 Audi A5. However, it is still accessible from the selected car via links, so may be relevant.

Tightening specification. Refer to OVERVIEW - OIL PAN/OIL PUMP .

Install in reverse order of removal. Note The Following:

NOTE:

Replace The Gaskets And Seals.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Install the After-Run Coolant Pump -V51-. Refer to After-Run Coolant Pump -V51-, REMOVING AND INSTALLING .

-- Install the lock carrier brace. Refer to LOCK CARRIER .

-- Check the oil level. Refer to OIL LEVEL, CHECKING

-- Fill the coolant. Refer to COOLANT, DRAINING AND FILLING .