Overview - Radiator/Coolant Fan
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
WARNING:
Danger of personal injury due to the coolant fan turning on by itself.
- Disconnect the connectors before working near the fan shroud.
- Bolt
- 5 Nm
- Bolt
- 5 Nm
- Fan Shroud
- Removing and installing. Refer to FAN SHROUD, REMOVING AND INSTALLING .
- Coolant Fan -V7-
- With Coolant Fan Control Module -J293-
- Removing and installing. Refer to COOLANT FAN, REMOVING AND INSTALLING .
- Bolt
- 3.5 Nm
- Backing
- Rubber Bushing
- For the radiator
- Coolant Hose
- Lift the retaining clamp to remove
- O-ring
- Always replace
- Coolant Hose
- To the coolant reservoir
- O-ring
- Always replace
- Radiator
- Removing and installing. Refer to RADIATOR, REMOVING AND INSTALLING .
- Change the coolant after replacing
- Retaining Pin
- Disengage and remove using screwdriver
- Rubber Buffer
- Radiator Bracket
- Bolt
- O-ring
- Always replace
- Coolant Hose
- Lift the retaining clamp to remove
- Coolant Fan 2 -V177-
- With Coolant Fan Control Module 2 -J671-
- Removing and installing. Refer to COOLANT FAN, REMOVING AND INSTALLING .