Overview - Coolant Pump/Thermostat: Notes

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Exploded View Of Coolant Pump And Coolant Regulator With Components

Courtesy of AUDI OF AMERICA, LLC

Seal
- Always replace
Coolant Pump Housing
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
Bolt
- Tightening Specification. Refer to OVERVIEW - COOLANT PIPES .
Front Coolant Pipe
- Removing and installing. Refer to FRONT COOLANT PIPE, REMOVING AND INSTALLING .
O-ring
- Always replace
Seal
- Always replace
Coolant Pump
- Removing and installing. Refer to COOLANT PUMP, REMOVING AND INSTALLING .
O-ring
- Always replace
Bolt
- 9 Nm
Coolant Pump Driveshaft
O-ring
- Always replace
Map Controlled Engine Cooling Thermostat -F265-
- Removing and installing. Refer to Map Controlled Engine Cooling Thermostat -F265-, REMOVING AND INSTALLING .
- Thermostat opening data. Refer to COOLANT THERMOSTAT OPENING DATA
O-ring
- Always replace
Oil Drain Plug
- 4 Nm
Bolt
- 9 Nm