Coolant Connections, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening Specification. Refer to OVERVIEW - COOLANT PIPES .

NOTE:

Secure All Hose Connections With Hose Clamps Of The Same Type As Those Equipped By The Factory.

When installing, bring all cable ties back to same positions.

-- Clean or smooth the sealing surface.

-- Install right coolant pipe. Refer to RIGHT COOLANT PIPE, REMOVING AND INSTALLING .

-- Install the air filter housing. Refer to AIR FILTER HOUSING, REMOVING AND INSTALLING .

-- Install the plenum chamber bulkhead. Refer to LOCK CARRIER .

-- Install the vacuum pump. Refer to VACUUM PUMP .

-- Fill with coolant. Refer to FILLING