Upper Left Coolant Pipe, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening Specification. Refer to OVERVIEW - COOLANT PIPES .

NOTE:

Replace Oil Dipstick Guide Tube O-Ring.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Connect the coolant hose with the connector on the coolant pipe. Refer to Figure

-- Install oil dipstick guide tube. Refer to OVERVIEW - CRANKSHAFT .

-- Install the selector lever cable. Refer to the appropriate Service Information .

-- Install the ATF lines. Refer to the appropriate Service Information .

-- Install the left catalytic converter. Refer to LEFT CATALYTIC CONVERTER, REMOVING AND INSTALLING .

-- Install the exhaust system free of tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .

-- Attach the steering intermediate shaft to the steering gear. Refer to STEERING COLUMN .

-- Install the front crossmember. Refer to FRONT AXLE .