Rear Coolant Pipe, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening Specification. Refer to OVERVIEW - COOLANT PIPES .

NOTE:

Replace The O-Rings.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

When installing, bring all cable ties back to same positions.

-- Clean and/or smooth the sealing surfaces of the O-rings.

-- Coat the new O-ring with coolant.

-- Connect the coolant hose with the connector on the coolant pipe. Refer to Figure.

-- Install the plenum chamber bulkhead. Refer to LOCK CARRIER .

-- Fill with coolant. Refer to FILLING .