Secondary Air Injection Pump Motor -V101-, Removing And Installing, With Vacuum Control: Removing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Fig 1: Automatic Transmission Fluid Oil Pan

Courtesy of AUDI OF AMERICA, LLC

-- Remove the front noise insulation -1-. Refer to NOISE INSULATION .

-- Disconnect the connector -3- from the Secondary Air Injection Pump Motor -V101-.

Fig 2: Component Location Of Secondary Air Injection (AIR) Pump Motor -V101-

Courtesy of AUDI OF AMERICA, LLC

-- Disconnect the hoses -1 and 2- for the Secondary Air Injection (AIR).

-- Unlock the catches -arrows A- and remove the right air intake grille -1- from the lower part of the bumper cover -arrow B-.

Fig 3: Release Clamps Arrows And Remove Air Intake Grille

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The illustration shows the left air intake grille instead.

-- Remove the bolts -1 and 2- and remove the bumper cover noise insulation toward the rear.

Fig 4: Identifying Bolts & Front Bumper Cover End Plate

Courtesy of AUDI OF AMERICA, LLC

-- Remove the bolts -arrows- and remove the AIR pump.

Fig 5: Identifying Bolts & Secondary Air Pump

Courtesy of AUDI OF AMERICA, LLC

NOTE:

The Installation Location Is Shown With The Bumper Cover Removed.