Overview - Secondary Air Injection System Without Vacuum Control
WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.
- Nut
- 9 Nm
- Bonded Rubber Bushing
- Secondary Air Injection Pump Motor -V101-
- Installed location: in the front of the engine compartment on the right side under the longitudinal member
- Removing and installing. Refer to Secondary Air Injection Pump Motor -V101-, REMOVING AND INSTALLING, WITHOUT VACUUM CONTROL .
- Checking in Guided Functions . Refer to Vehicle Diagnostic Tester
- Bolt
- 9 Nm
- Spring Nut
- Secondary Air Hose
- From air filter housing
- Bolt
- 9 Nm
- Seal
- Always replace
- Bolt
- 9 Nm
- Connecting Pipe
- To right cylinder head
- Bolt
- 9 Nm
- Seal
- Always replace
- Right Secondary Air Injection Combination Valve
- Installed location: on the back of the right cylinder head
- Checking. Refer to SECONDARY AIR INJECTION (AIR) SOLENOID VALVE, CHECKING, WITHOUT VACUUM CONTROL .
- Removing and installing. Refer to RIGHT COMBINATION VALVE, REMOVING AND INSTALLING, WITHOUT VACUUM CONTROL .
- Bolt
- 9 Nm
- Secondary Air Hose
- To Secondary Air Injection (AIR) combi-valves
- Left Secondary Air Injection Combination Valve
- Installed location: on the back of the left cylinder head
- Checking. Refer to SECONDARY AIR INJECTION (AIR) SOLENOID VALVE, CHECKING, WITHOUT VACUUM CONTROL .
- Removing and installing. Refer to LEFT COMBINATION VALVE, REMOVING AND INSTALLING, WITHOUT VACUUM CONTROL .
- Seal
- Always replace
- Bolt
- 9 Nm
- Bolt
- 9 Nm
- Connecting Pipe
- To the left cylinder head
- Bolt
- 9 Nm
- Seal
- Always replace
- Secondary Air Injection (AIR) pipe
- From Secondary Air Injection Pump Motor -V101- to secondary air injection combi-valves
- Bolt
- 9 Nm
- Secondary Air Hose
- To Secondary Air Injection (AIR) combi-valves
- Bracket
- For Secondary Air Injection Pump Motor -V101-