Right Exhaust Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening Specification. Refer to Figure.

NOTE:

Replace Seal And Self-Locking Nuts.

Secure all hose connections with hose clamps of the same type as those equipped by the factory.

-- Place the seal on the stud bolts.

Fig 1: Right Exhaust Manifold Nut Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Insert exhaust manifold in securing strips and tighten the nuts. Refer to Figure.

-- Install the right engine mount. Refer to RIGHT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Install right coolant pipe. Refer to RIGHT COOLANT PIPE, REMOVING AND INSTALLING .

-- Install the right front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .

-- Install the right catalytic converter: Vehicles with manual transmission. Refer to RIGHT CATALYTIC CONVERTER, REMOVING AND INSTALLING, MANUAL TRANSMISSION , RIGHT CATALYTIC CONVERTER, WITH AUTOMATIC TRANSMISSION, REMOVING AND INSTALLING .

-- Install the vacuum pump. Refer to the appropriate Service Information .

-- Install the plenum chamber bulkhead. Refer to LOCK CARRIER .

-- Install the right front wheel housing liner. Refer to WHEEL HOUSING LINER .

-- Fill with coolant. Refer to COOLANT, DRAINING AND FILLING - Filling .