Left Exhaust Manifold, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening Specification. Refer to Figure.

NOTE:

Replace Seal And Self-Locking Nuts.

When installing, bring all cable ties back to same positions.

-- Place the seal on the stud bolts.

Fig 1: Left Exhaust Manifold Nut Tightening Sequence

Courtesy of AUDI OF AMERICA, LLC

-- Insert exhaust manifold in securing strips and tighten the nuts. Refer to Figure.

-- Install the left engine mount. Refer to LEFT ENGINE MOUNT, REMOVING AND INSTALLING .

-- Install the left front wheel housing liner. Refer to Wheel Housing Liner .

-- Installing the upper left coolant pipe. Refer to UPPER LEFT COOLANT PIPE, REMOVING AND INSTALLING .