Left Catalytic Converter, Removing And Installing: Installing

WARNING: This page is about a different car, the 2012 Audi S5, 2011 Audi S5, 2010 Audi S5, 2009 Audi S5, and 2008 Audi S5. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal. Note The Following:

Tightening Specification. Refer to OVERVIEW - MUFFLER .

NOTE:

Replace seals and self-locking nuts.

-- Attach the steering intermediate shaft to the steering gear. Refer to STEERING COLUMN .

-- Install the ATF lines. Refer to the appropriate Service Information .

-- Install the subframe crossbrace. Refer to SUBFRAME CROSSBRACE, REMOVING AND INSTALLING .

-- Install the upper control arm. Refer to UPPER CONTROL ARM, REMOVING AND INSTALLING .

-- Install the stabilizer bar. Refer to STABILIZER BAR, REMOVING AND INSTALLING .

-- Tighten the suspension strut to the control arm. Refer to Lower Control Arm and Ball Joint .

-- Install the Heated Oxygen Sensor 2 -G108- and Oxygen Sensor 2 after Catalytic Converter -G131-. Refer to HEATED OXYGEN SENSOR 2 -G108- AND OXYGEN SENSOR 2 AFTER CATALYTIC CONVERTER -G131-, REMOVING AND INSTALLING, CYLINDER BANK 2 .

-- Install the left front muffler. Refer to FRONT MUFFLER, REMOVING AND INSTALLING .

-- Install the exhaust system without tension. Refer to EXHAUST SYSTEM, INSTALLING WITHOUT TENSION .